초록

In this study, the thermal behavior of adaptor housing was analyzed by the numerical method. The boundary conditions used to die casting process were the temperature of molten metal and injection time. As the temperature of the molten metal increased, the tensile strength of the product decreased by the blow hole generated in the molten metal, and the decreasing tendency was gradually decreased. As the injection time ofthe molten metal increased, the heat flux rose, but the degree of the increase was very small. So, the injection time of the molten metal had little effect on the thermal behavior and diffusion of the adapter housing. As a result, the heat of the molten metal was transferred into the housing and the thermal behavior spread widely.

키워드

Adaptor Housing(어댑터 하우징), Computational Fluid Dynamics(전산유체역학), Heat Flux(열유속), Molten metal(용탕), Thermal Characteristics(열적특성)

참고문헌(9)open

  1. [학술지] 고동국 / 2015 / 탄소복합재 브레이크 디스크의 통풍구 형상에 따른 유동특성에 관한 해석적 연구 / 한국자동차공학회 논문집 23 (2) : 191 ~ 198

  2. [학술지] 박경민 / 2013 / 하이브리드 상용트럭 에어 브레이크 챔버 요소부품의 구조적 해석 연구 / 한국기계기술학회지 15 (5) : 717 ~ 723

  3. [학술지] 김진택 / 2014 / 상용 트럭의 공압 브레이크 제동 특성에 미치는 인자에 대한 연구 / 한국산학기술학회논문지 15 (1) : 8 ~ 13

  4. [학술지] T. R. Vijayaram / 2006 / Numerical simulation of casting solidification in permanent metallic molds / Journal of Materials Processing Technology 178 : 29 ~ 33

  5. [학술지] S. V. Shepel. / 2002 / Numerical simulation of filling and solidification of permanent mold casings / Applied Thermal Engineering 22 : 229 ~ 248

  6. [학술지] O. Richmond. / 1971 / Theory of Thermal Stress and Air-Gap Formation during the Early Stages of Solidification in a Rectangular Mold / Journal of Mechanical Physics and Solids 19 : 273 ~ 284

  7. [학술지] 박창선 / 2011 / 차량의 연료압력 레귤레이터 성형해석 / 한국생산제조학회지 20 (2) : 151 ~ 156

  8. [학술지] 고동국 / 2016 / 타이어 몰드 표면에서의 열유속 및 열전달 시간에 따른 몰드의 온도분포에 관한 수치해석 연구 / 한국기계기술학회지 18 (6) : 893 ~ 898

  9. [기타] / 2015 / KS D 2331:2009, Aluminium alloy ingots for die casting / Korean Agency for Technology and Standards